We have Different models of Combined Shower Units. Floor mounted with hand or foot control, with platform and barrier, wall mounted...

Model P/N: RTS-70

RTS-70 Pedestal Mounted Stainless Steel Push Handle Control:

Water Inlet: 1 1/4"

Water Outlet: 1 1/4" for Eye Face Shower

Shower Material: Stainless Steel 304 AISI

Shower Head Bowl and Eye Face bowl: 280 mm

Shower open arm is according to EN 420

Signs are comply with ISO 3864-1

Standards and design norms: EN 15154-1-2 and ANSI Z358.1-2009

Model P/N: RTS-71

RTS-71 Pedestal Mounted Galvanized Steel Painted Push Handle Control:

Water Inlet: 1 1/2"

Water Outlet: 1 1/2" for Eye Face Shower

Shower Material: Galvanized Steel Painted

Shower Head Bowl and Eye Face bowl: 280 mm

Shower open arm is according to EN 420

Signs are comply with ISO 3864-1

Standards and design norms: EN 15154-1-2 and ANSI Z358.1-2009

Model P/N: RTS-71ATEX

RTS-71 Combined Shower Station for Outdoor Installation from Galvanized Steel with ATEX Components

*Floor mounted self-drain emergency shower & eyewash (independent operation), stainless steel shower head

*This floor mounted, self-draining combination shower & eyewash is fitted with automatic drain valve to remove water from the pipe work and reduce the risk of overheating or freezing dependent on the climate the shower is being used in.

* The galvanized pipe work is protected with an anti-corrosive thermoplastic coating. All fittings are galvanized and the 250mmØ shower head is manufactured from stainless steel.

* EN15154 parts 1 & 2 , DIN 12899.3 ,ANSI Z358.1

* Water inlet: 1 1/2" ASME B16.5 raiting 150

*Water inlet pressure: Recommended 2 bar

*Shower flow rate: Regulated at 110lpm

*Shower operation: Pull rod handle

*Shower valve: Full bore 1"

*Eyewash flow rate: 22lpm

*Eyewash operation: Push Handle and 60x100 cm stainless steel foot platform

*Eyewash valve: Full bore ½"

*Waste: 1/2" Scald Valve outlet and automatic drain valve outlet

*ATEX audio alarm & strobe light and an enclosure/junction box with 16A isolators

*ATEX fixed light

*Insulated jacket(ABS shell + 2.5 cm thickness glass wool with aluminium) to provide additional protection from extremes of temperature

* Anti Scald valve

*ATEX certified Flow Switch which can be connected with control room

* Automatic drain valve and inlet ball valve

Model P/N: RTS-71HTNF

RTS-71HTNF Combined Shower unit for Outdoor Installation Heat Traced Insulated Freeze Resistant from Galvanized Steel with Audible and Light Alarm

Pipes are covered with resistant cable spirally. Glass wool and aluminium 2,5 cm insulation is applied to pipes. This system is put into ABS shell. There is thermostat with set value of 1.7 degree which run it to 5 degree. Outlet of showers is connected with non freezing valve. water is released by non freezing valve. resistant is between 10W/m -20W/m. warning lamp, digital indicator, flow switch. push handle. galvanized painted steel showers.

Available for hazardaus and non-hazardaus areas .
20 - 25 W/m , AC 230 V , Ex-proff Cable Heating with insulation for freeze protection
304 Galvanized Steel powder coated .
1 . 1 / 2 " Pipe Top and Bottom inlet 1 . 1 /2" or 1 . 1 / 4" .
Shower Head : Stainless Steel and/or Galvanized Steel or ABS Plastic 300 mm Diameter
Water Flow : 75,7 lt Body shower 11,5 lt Eyewash
Audible and Light Alarm
Digital Thermostat.
Flow Switch

Model P/N: RTS-72

RTS-72 Pedestal Mounted Galvanized Steel Painted Push Handle Control:

Water Inlet: 1 1/2"

Water Outlet: 1 1/2" for Eye Face Shower

Shower Material: Galvanized Steel Painted

Shower Head Bowl and Eye Face bowl: 280 mm Stainless Steel

Shower open arm is according to EN 420

Signs are comply with ISO 3864-1

Standards and design norms: EN 15154-1-2 and ANSI Z358.1-2009

Model P/N: RTS-73

RTS-73 Pedestal Mounted Galvanized Steel Painted Push Handle Control:

Water Inlet: 1 1/2"

Water Outlet: 1 1/2" for Eye Face Shower

Shower Material: Galvanized Steel Painted

Shower Head Bowl and Eye Face bowl: 280 mm ABS

Shower open arm is according to EN 420

Signs are comply with ISO 3864-1

Standards and design norms: EN 15154-1-2 and ANSI Z358.1-2009